audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear bumper (from chassis number 8D XA 200 001) > < Rear bumper

A4 Mk1

General Body Assembly
Rear bumper
Removing and installing rear bumper (up to chassis number 8D XA 200 000)
  • Bumper
    • ◆ To remove, unscrew combi bolts -6-.
    • ◆ Unclip bumper in direction of arrow from bracket -4- and detach to rear.
  • Spoiler
    • ◆ Removing and installing =>Page 63-9
  • Clip
  • Bracket
    • ◆ To remove, unscrew self-tapping screws -5- and detach bracket.
  • Self-tapping screw
  • Combi bolt
    • ◆ 23 Nm
  • Impact absorber
    • ◆ Removing from bumper =>Fig.1.
 
A63-0009

Fig.1    → Removing impact absorber from bumper

  • ‒ Unscrew bolts -arrows- and take impact absorber -1- out of bumper -2-.
  • ‒ On installation, tighten to 23 Nm.

Removing and installing rear bumper (from chassis number 8D XA 200 001) > < Rear bumper