Audi Workshop Service and Repair Manuals

Note:

Protective trim strips cannot be removed without destroying them.

• ‒ → Surface to be bonded must be clean and free from grease.

Protective trim strips are only to be bonded at room temperature.
Vehicle and protective trim strips should be left standing at room temperature for at least 2 hours before performing work.

• ‒ Pull off backing -4- shortly before fitting.

Once backing has been removed, protective trim strips must be bonded within 90 minutes.

• ‒ Start bonding protective trim strip -1-; -2- or -3- at front with guide pin and work towards rear.
• ‒ Press or roll on protective trim strips, applying a pressure of 100 N/cm.
• ‒ After bonding strip, vehicle must be left standing at room temperature for a further 4 hours.