Audi Workshop Service and Repair Manuals

• Mirror housing
• ◆ Can be removed from door without dismantling entire rear-view mirror =>Page 66-18.
• Mirror adjuster unit
• ◆ Remove mirror from door before removing adjuster unit.
• ‒ To remove, lever off mirror glass, unplug electrical connectors for mirror heater, unscrew cross-head bolts -6- and take mirror adjuster unit out of mirror housing -1-.

Note:

• ◆ On vehicles with a seat memory, the door trim has to be removed before removing the mirror adjuster unit.

• Door subframe
• Hexagon socket-head bolt
• ◆ 12 Nm
• Seal
• ◆ When installing, make sure seal is seated correctly.
• Cross-head screw
• ◆ 1 Nm
• Mirror glass
• ‒ Use special tool 80-200 (assembly lever) to unclip mirror glass.
• ‒ Protect top and bottom of mirror housing from damage with fabric-backed adhesive tape.
• ‒ Lever off mirror glass at the bottom first, then at the top.

• ‒ To install, enter mirror glass into guide stud and friction finger into friction spring, and press on.
• ‒ Always use protective gloves, and only exert pressure at centre of glass.

• Friction finger
• ◆ When installing the mirror glass, friction finger -8- must be inserted into friction spring -9- in housing.
• Friction spring