Audi Workshop Service and Repair Manuals

→ Joint dimensions:

• ‒ a =4 mm±0.5
• ‒ b=5 mm±0.5
• ‒ c=3.5 mm -0.5/+1

Adjusting to body contour:

• ‒ The door is adjusted by the hinge screws on the B-pillar and sliding the door (oversized drilled holes in hinge).

Note:

Rear part of door is adjusted to centre of vehicle using striker plate =>Fig.1.

Fig.1    Adjustment with striker wedge

Note:

Rear part of door is adjusted at striker plate.

When installed, there must not be any torsion between striker plate and door lock.

• ‒ → Release bolts.
• ‒ Move striker plate until door shell is flush with body contour.
• ‒ Tighten bolts.
  Tightening torque 20 Nm.