Audi Workshop Service and Repair Manuals

• Operating rod
• ◆ Adjusting:
• ‒ Insert operating rod in hinged bushing -2-.
• ‒ Clip operating rod into operating clips -3- without straining door lock release lever (max. play 1.5 mm).
• ‒ Push sliding sleeve -4- upwards onto the operating clip -3- and engage on it.
• ‒ Clipping-in length -4a- 13 ±3 mm.
• ‒ Do not remove locating pin -4- from door lock until operating rod has been installed.
• Hinged bushing
• Operating clip

• Locating pin
• ◆ Only available for replacement part, locates the basic setting.
• ◆ Do not remove until operating rod -1- has been installed.
• Bowden cable for door locking
• ◆ Removing and installing => Fig.4.

Fig.1    Bowden cable for door locking

• ‒ To remove, unclip Bowden cable -2- from holder -1- and press out of support bracket -3-.