Audi Workshop Service and Repair Manuals

• Bolt (4x)
• ‒ Tightening torque 5 Nm
• Front section of centre console

• ◆ Removing
• ‒ Remove rear section of centre console
• ‒ Remove trim for centre section of dash panel =>Fig.: 4
• ‒ Unscrew heater control from centre section of instrument panel =>Fig.:3.
• ‒ Unclip cover -3-.
• ‒ Unscrew nut -4-.
• ‒ Unscrew bolts -1- (4x).
• ‒ Disengage centre console from position -A- and pull out to rear.

• ◆ Installing
• ‒ On installation centre console must be inserted into fastener -5-.

• Cover
• Nut
• ‒ Tightening torque 3.5 Nm
• Fastener

Fig.:3    Removing centre section of dash panel

• ‒ → Unscrew bolts -2- (4x). Tightening torque 5 Nm.
• ‒ On vehicles with air conditioning unscrew bolts -4- (2x). Tightening torque 3.5 Nm.
• ‒ On vehicles with heater unscrew bolts -6- (4x). Tightening torque 5 Nm.
• ‒ Disengage centre section of dash panel -1- at top from the two guides, pull it forward slightly and detach wiring.
• ‒ Tray -3- is only unclipped.

Fig.:4    Removing cover for dash panel centre section

• ‒ Removing radio.

=> Electrical Systems; Repair group 91.

• ‒ On vehicles with heater: Pull off heater control knobs -3- (3x) and unscrew bolts -4- (2x). Tightening torque 3.5 Nm.
• ‒ → Unscrew bolts -2- (4x). Tightening torque 5 Nm.
• ‒ Unclip trim -1-.