Audi Workshop Service and Repair Manuals > A4 Mk1 > Body | General Body Assembly, Interior (Repair groups 68, 69, 70, 72, 74) | Seat frames | Rear seat | Removing and installing split backrest (Saloon)

General Body Assembly, Interior (Repair groups 68, 69, 70, 72, 74)

Rear seat

Removing and installing split backrest (Saloon)



2/3 backrest ◆ Removing: ‒ Unscrew bolt -8- and remove clip for centre support bracket -7-. ‒ Lift backrest out of centre support bracket -9- and pull out of fitting -4- towards centre of vehicle. ◆ Installing: ‒ Install in reverse order. 1/3 backrest ◆ As 2/3 backrest. Bolt (2x) ‒ Tightening torque 16 Nm Fitting Guide for backrest



Bolt (4x) ‒ Tightening torque 16 Nm Centre support bracket Bolt ‒ Tightening torque 12 Nm Centre support bracket Catch Back panel Luggage compartment trim Shim plate Bolt ‒ Tightening torque 8 Nm

Audi Workshop Service and Repair Manuals