Audi Workshop Service and Repair Manuals

Removing

• ‒ Remove front centre console:

=> General Body Assembly, Interior; Repair group 68; Storage compartments/covers; Removing and installing front part of centre console

• ‒ Loosen footwell vent from the right dash panel support .
• ‒ Detach the connector from the positioning motor.

Note:

Mark the connectors on the positioning motor, so they are not interchanged.

• ‒ → Screw out the bolts -A-.
• ‒ Remove the positioning motor.
• ‒ Unclip the reversing lever -B- (colour code: red).

Installing

Installation is carried out in the reverse order; note the following:

• ‒ → When installing the positioning motor, check that the reversing lever -B- is seated correctly.
• ‒ Lay the wiring harness so that it cannot come into contact with moving components (e.g. the positioning motor lever)
• ‒ Interrogate fault memory => Page 01-63.