Audi Workshop Service and Repair Manuals

Note:

In right-hand drive vehicles, the air conditioner is dismantled and assembled in the same way as vehicles up to Model Year 1996 .

• ‒ Remove the air conditioner

• Evaporator housing
• ◆ Dismantling and assembling => Page 87-196
• Threaded plate
• Bracket
• ◆ Mark the installation position before loosening the bolts.

• Fresh-air blower -V2
• ◆ With fresh-air blower control unit -J126
• ◆ Removing and installing fresh air blower -V2 => Page 87-102
• ◆ Removing and installing fresh air blower control unit -J126 => Page 87-104
• Bolt
• Bolt
• Temperature flap positioning motor -V68
• ◆ With temperature flap positioning motor potentiometer -G92
• ◆ Colour code for the reversing lever red
• ◆ Removing and installing

• Central flap positioning motor
  -V70
• ◆ With central flap positioning motor potentiometer -G112
• ◆ Colour code for the reversing lever Blue
• ◆ Removing and installing
• Footwell vent temperature sensor -G192
• ◆ Removing and installing
• Footwell/defroster flap positioning motor -V85:
• ◆ With footwell/defrost flap positioning motor potentiometer -G114
• ◆ Removing and installing

• Heat exchanger
• ◆ Removing and installing
• ◆ Attaching self-adhesive seal => Page 80-29
• Grommet
• ◆ Check correct seating
• ◆ In the grommet is not fitted, cold air may enter the footwell
• Foam seal
• ◆ Provides a seal between the air conditioner's condensation drain and the drain funnel

• Air-flow flap positioning motor -V71
• ◆ With air-flow flap positioning motor potentiometer -G113
• ◆ Actuates the air-flow flap and fresh-air and recirculated-air flap
• ◆ Removing and installing
• Fresh air intake duct temperature sensor -G89
• ◆ Removing and installing