Audi Workshop Service and Repair Manuals

Note:

• ◆ Lubricate bearings and moving surfaces with polycarbamide grease, part No. G 052 142 A2.
• ◆ Adjusting gear selector mechanism
  =>Page 34-16.

• Ball stop
• ◆ Insert spring and bush in the ball stop and assemble on the gear stick so that the spring and bush are on the right when looking forwards.
• ◆ Install ball stop before fitting circlip (item 19).
• Spring
• Spacer sleeve

• Circlip
• ◆ Renew circlips if they have been over-stretched
• Sealing collar
• Bush
• Retaining frame - lower section
• Retaining frame - top section
• Cover
• ◆ Retaining hook on rear of cover; prise out carefully from centre console
• Bush
• Gear stick knob

• Spring
• Bush
• ◆ Fitting position: The rounded end faces the gear stick
• Gear stick
• ◆ Can only be fitted into ball housing in one position
• Spacer tube
• Nut - 8 Nm
• Noise insulation
• Nut - 8 Nm
• Circlip
• ◆ Renew
• ◆ Remove before removing the ball stop
• ◆ Fitting position: the rounded side faces to ball housing (item 20)

• Ball housing
• ◆ Limit pieces for ball stop on left and right must be engaged
• ◆ Installation position: reverse detent faces left
• Buffer
• Hexagon socket head bolt
  - 23Nm
• Rear push rod
• ◆ In gear selector mechanism
• Washer
• Hexagon socket head bolt
  - 23Nm
• Connector
• Collar nut - 23 Nm