audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing manual gearbox and selector shaft > < Dismantling and assembling gearbox

A4 Mk1

6-speed manual gearbox 01E Four-wheel drive
Dismantling and assembling gearbox
Removing and installing bearing housing, Torsen differential and end cover
 
V34-2819
  • Bearing housing
    • ◆ Dismantling and assembling
  • Bolt, 25 Nm
    • ◆ 6x
  • Dished washer
    • ◆ Installation position: Large diameter (concave side) facing shims
  • Shim
    • ◆ 2 or 3x
    • ◆ Re-determining thickness
      => Page 34-202
  • Oil collector
    • ◆ Dismantling and assembling
      => Page 34-199
    • ◆ Removing => Page 34-174
    • ◆ Installing => Page 34-200
 
V34-2819
  • Multi-point socket-head bolt - 150 Nm
    • ◆ Screwing out => Page 34-176
    • ◆ Screwing in => Page 34-199
  • 2nd inner race for ball bearing for input shaft
    • ◆ Removing => Page 34-177
    • ◆ Installing => Page 34-198
  • Spring
  • Torsen differential
    • ◆ Can only be serviced by the manufacturer
    • ◆ Servicing bearing system for Torsen differential => Page 34-215
  • Bolt, 25 Nm
    • ◆ 5x
  • End cover
    • ◆ Servicing => Page 34-222
 
V34-2819
  • Gasket
    • ◆ Replace
  • Dowel sleeve
    • ◆ 2x
  • Manual gearbox
    • ◆ 5. Removing and installing 5th and 6th gear => Page 34-161
    • ◆ Removing and installing input shaft, drive pinion, hollow shaft and gearbox shift mechanism=> Page 34-165
  • Oil drain plug, 40 Nm
  • Magnet
    • ◆ 2x
    • ◆ Clean
  • Support plate
    • ◆ Installation position: Lug facing magnets
  • Bolt, 25 Nm
    • ◆ 2x

Removing and installing manual gearbox and selector shaft > < Dismantling and assembling gearbox