audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Ribbed belt layout > < Removing and installing vibration damper

A4 Mk1

4-Cyl. TDI®Engine, Mechanics
Dismantling and assembling engine
Ribbed belt drive for air conditioner - Exploded view
 
A13-0104
Attention:
Never open refrigerant circuit of air conditioner.

Note:

Mark direction of ribbed belt with chalk or felt-tip pen prior to removal. Running a used belt in the opposite direction could destroy it. When installing belt, make sure it is properly seated on pulleys.

  • Bracket
 
A13-0104
  • Air conditioner compressor
    • ◆ After detaching, attach compressor to longitudinal member, e.g. using a piece of wire; never leave hanging from refrigerant pipes
    • ◆ Do not unscrew/detach refrigerant pipes
  • Dowel sleeve
    • ◆ Check correct fit in bracket
  • 25 Nm
  • Bracket
    • ◆ For air-conditioner compressor
  • Tensioning roller
    • ◆ For ribbed belt
    • ◆ Removing and installing ribbed belt => Page 13-23
 
A13-0104
  • Washer
  • 25 Nm
  • Ribbed belt
    • ◆ Removing and installing=>Page 13-23
    • ◆ Check for wear
    • ◆ Do not kink
    • ◆ Position of ribbed belt =>Page 13-21
  • Washer
  • 25 Nm
    • ◆ Make exclusive use of genuine bolts (bolt strength 10.9)

=> Parts List

  • Retaining clip
  • 10 Nm

Ribbed belt layout > < Removing and installing vibration damper