Audi Workshop Service and Repair Manuals

Note:

Servicing clutch:

=> 5-speed manual gearbox 012/01W Front-wheel drive; Repair Group 30; Servicing clutch

=> 6-speed manual gearbox 01/E Four-wheel drive; Repair Group 30; Servicing clutch

• Front sealing flange
• ◆ Must rest on dowel sleeves
• ◆ Apply silicone sealant on installation
• ◆ Sealant => Parts catalogue
• ◆ Removal and installation involve taking out sump => Page 17-10
• ◆ Removing and installing=>Page 13-61
• 15 Nm

• Sealing ring
• ◆ Replacing => Page 13-56
• ◆ Do not oil sealing lip of sealing ring
• Sump
• ◆ Removing and installing=>Page 17-10
• 15 Nm
• cylinder block
• ◆ Removing and installing crankshaft
  => Page 13-72
• ◆ Dismantling and assembling piston and conrod => Page 13-84
• Dual-mass flywheel/drive plate
• ◆ Removing and installing dual-mass flywheel => Page 13-67
• ◆ Removing and installing drive plate
  => Page 13-69

• Bolt for dual-mass flywheel/drive plate
• ◆ Replace
• ◆ Tightening torque for dual-mass flywheel=>Page 13-68
• ◆ Tightening torque for drive plate
  (vehicles with automatic gearbox)
  => Page 13-71
• Intermediate plate
• ◆ Must rest on dowel sleeves
• ◆ Take care not to damage/bend on assembly
• ◆ On vehicles with manual gearbox and four-wheel drive, an intermediate (plate thickness 5.5 mm) must additionally be fitted

• 15 Nm
• Rear sealing flange with oil seal
• ◆ With gasket for cylinder block
• ◆ Do not oil sealing lip of sealing ring
• ◆ A sealing flange with an offset oil seal is supplied as a spare
• ◆ Removal and installation involve taking out sump => Page 17-10
• ◆ On fitting, slip guide sleeve from installation set over crankshaft