Audi Workshop Service and Repair Manuals

Renewing inlet camshaft oil seal Special tools and workshop equipment required

t  Oil seal extractor -2085-

t  Assembly tool -T10071-

Procedure l  Lock carrier must be in service position → Rep. Gr.50. –  Release quick-release fasteners and remove engine cover panel -arrows-.

–  Unplug electrical connector -arrow- at Hall sender -G40-. –  Remove toothed belt cover (top section) –  Remove Hall sender → Item, → Item and → Item.

–  To guide oil seal extractor, screw bolt -2085/1- by hand into camshaft as far as it will go. –  Unscrew inner section of oil seal extractor -2085- two turns (approx. 3 mm) out of outer section and lock inner section with knurled screw.

–  Lubricate threaded head of oil seal extractor -2085-, place it in position and screw it into oil seal as far as possible (applying firm pressure). –  Loosen knurled screw and turn inner section of oil seal extractor against camshaft until oil seal is pulled out. –  Clamp flats of oil seal extractor in vice and use pliers to remove oil seal. –  Clean contact surface and sealing surface.

–  Fit guide sleeve -T10071/5- onto camshaft journal.   Note Do not lubricate sealing lip of oil seal. –  Push oil seal over guide sleeve onto shaft journal. –  Take off guide sleeve.

–  Press oil seal in onto stop using press sleeve -T10071/3- and M8x60 bolt. –  Install Hall sender → Item, → Item and → Item. –  Install toothed belt cover (top section). Tightening torques → Chapter