audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head|Part II > < Removing and installing cylinder head

A4 Mk1

4-Cylinder engine (2-valve), Mechanics
Removing and installing cylinder head
Part I
 
A15-0218
  • Toothed belt guard - rear
  • 20 Nm
  • Cylinder head
    • ◆ Removing
    • ◆ Check for distortion => Fig. 1
    • ◆ Reworking limit => Fig.2
    • ◆ Installing => Page 15-23
    • ◆ After replacing, fill with fresh coolant
  • Cylinder head bolt
    • ◆ Renew
    • ◆ Note sequence when loosening => Page 15-22
    • ◆ Note sequence when tightening => Page 15-25
 
A15-0218
  • Oil deflector
  • Cylinder head cover gasket
    • ◆ Renew if damaged or leaking
    • ◆ Before fitting gasket apply "D 454 300 A2" at sealing points shown in Fig. 3 and Fig. 4
  • Cylinder head cover
    • ◆ Removing and installing
      => Page 15-16
  • Toothed belt guard
  • 10 Nm
  • Cap
  • Gasket
    • ◆ Renew if damaged or leaking
 
A15-0218
  • Bracket
  • O ring
    • ◆ Renew if damaged
  • Securing clip
  • Hose
    • ◆ For crankcase breather
  • 10 Nm
  • Reinforcement strip
  • 10 Nm
  • Flange
  • Gasket
    • ◆ Renew
 
A15-0218
  • Cylinder head gasket
    • ◆ Renew => "Removing cylinder head, Page 15-18
    • ◆ Position: Part No. towards cylinder head
    • ◆ After replacing, fill with fresh coolant
  • Lifting eye
  • 20 Nm

Removing and installing cylinder head|Part II > < Removing and installing cylinder head