audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Tightening torque > < Removing

A4 Mk1

Installing
Installing
   
–  Fit drive plate with shim -2- and washer -1-. Lug -arrow- must face torque converter.
–  Insert at least 3 old securing bolts and tighten to 30 Nm.
  V13-0851
–  Check installation position of drive plate by measuring at three points and calculate average.
l  Specification for automatic gearbox 01N: dimension -a- = 26 … 28 mm
  V13-1244
If specification is exceeded:
–  Remove drive plate again and fit without shim -2-. Tighten bolts to 30 Nm again.
–  Repeat measurement procedure.
If reading matches specification:
–  Renew bolts and tighten.
  V13-0851

Tightening torque > < Removing