Audi Workshop Service and Repair Manuals

Note:

Before removing the ribbed belt, mark the direction of rotation with chalk or a felt pen. If a used belt rotates in the wrong direction when refitted, it can break. When installing the belt, ensure it is correctly seated on the pulleys.

• 25 Nm

• Refrigerant pipes
• ◆ Do not unscrew or disconnect pipes
• Dowel sleeve
• ◆ Check that sleeve is correctly seated in bracket
• Bolt
• ◆ Bolt with strength rating 8.8:
  tighten to 25 Nm
• ◆ Bolt with strengthrating 10.9:
  tighten to 30 Nm

=> Parts catalogue

• Bracket
• ◆ For A/C compressor
• Tensioning roller
• ◆ For ribbed belt
• ◆ Removing and installing ribbed belt
• Washer

• 20 Nm
• Ribbed belt
• ◆ Removing and installing
  => Page 13-18
• ◆ Check for wear
• A/C compressor
• ◆ After removing compressor from mountings, secure it to chassis side member with wire or similar Do not leave it suspended on refrigerant hoses.
• ◆ Do not unscrew or disconnect refrigerant hoses or pipes.
• Washer