Audi Workshop Service and Repair Manuals

• 30 Nm
• ◆ Renew
• Gasket
• ◆ Renew
• Exhaust manifold
• ◆ Removing and installing
  
• Lambda probe, 50 Nm
• ◆ Grease only the threads with high-temperature lubricantG 052 112 A3.The lubricant mustnot get into the slots on the probe body.

• ◆ Checking:

=> Motronic injection and ignition system (4-cylinder); Repair Group 24: Testing lambda control

=> Motronic injection and ignition system (4-cylinder)07.96 ä; Repair group 24; Testing lambda control

• ◆ Unplugging lambda probe connector => Page 26-17

• 40 Nm
• Clamp
• ◆ Align exhaust system so it is free of stress before tightening clamp => Page 26-20.
• ◆ Installation position:
  bolted connection facing to the left.
• ◆ Position of bolts => Fig.1
• ◆ Tighten bolted connections evenly.

• 40 Nm
• Clamp
• ◆ For separate replacement of front and rear silencers
• ◆ Align exhaust system so it is free of stress before tightening clamp => Page 26-20.
• ◆ Installation position: bolted connection facing to the rear
• ◆ Position of bolts => Fig.1
• ◆ Tighten bolted connections evenly.
• 25 Nm
• Mounting
• Stop

• Mounting
• 25 Nm
• Rear silencer
• ◆ Rear silencer and front silencer are one unit as original equipment, but can be renewed separately for repair purposes.
• ◆ Cutting point => Page 26-13
• ◆ Aligning exhaust system free of stress => Page 26-20
• Front silencer
• ◆ Front and rear silencers are one unit as original equipment, but can be renewed separately for repair purposes
• ◆ Cutting point => Page 26-13
• ◆ Aligning exhaust system free of stress => Page 26-20
• Mounting

• 25 Nm
• Catalytic converter
• ◆ Protect from damage by knocks and impact
• 25 Nm
• ◆ Renew
• Gasket
• ◆ Renew
• 25 Nm
• Front exhaust pipe
• ◆ With flexible connection (de-coupling element)
• ◆ Do not bend flexible connection more than10°- otherwise it can be damaged
• ◆ To remove, unbolt floor cross member (20 Nm)
• ◆ Aligning exhaust system free of stress => Page 26-20