Audi Workshop Service and Repair Manuals

Removing

• ‒ Remove flange=>Removing fuel delivery unit, from Page 20-49.
• ‒ Pull out flange carefully and place to one side with wiring and hoses connected.
• ‒ Unplug connector for fuel gauge sender on inside of flange.

• ‒ → Press retaining tab, and at the same time pull the sender unit out of baffle housing in fuel tank -arrows-.

Notes:

• ◆ The baffle housing is shown without the fuel tank for a clearer illustration.
• ◆ The sender unit and baffle housing shown are for vehicles with front-wheel drive.

Installing

• ‒ Insert fuel gauge sender into guide on outer section of baffle housing and press down until it clicks into place.
• ‒ Install flange=>Page 20-54.
• ‒ After connecting battery, enter anti-theft code for radio

=> Radio operating instructions

• ‒ Close windows fully using electric window switches.
• ‒ Then operate all electric window switches again for at least one second in the "close" direction to activate the automatic one-touch function.
• ‒ Set clock to correct time.