Audi Workshop Service and Repair Manuals

Removing

• ‒ Remove front bumper:

=> General body repairs; Repair group 63; Front bumper; Removing and installing front bumper

• ‒ Move lock carrier to service position

=> General body repairs; Repair group 50; Removing and installing lock carrier; Lock carrier service position

• ‒ Remove ribbed belt .
• ‒ Remove toothed belt => Page 13-5.

• ‒ Remove sealing plug from hole in cylinder block (left side).
• ‒ Position crankshaft to TDC of No. 3 cylinder. The crankshaft TDC drilling should be visible (or it should be possible to feel the drilling) in the sealing plug hole.
• ‒ → Screw clamping bolt 3242 into hole so that the crankshaft is secured against turning.

• ‒ Then remove crankshaft toothed belt sprocket.
• ‒ Unscrew inner part of the oil seal extractor 3203 two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
• ‒ → Lubricate threaded head of oil seal extractor, place it in position and, exerting firm pressure, screw it in as far as possible into oil seal.
• ‒ Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.

Installing

• ‒ Place guide sleeve 3202/1 onto crankshaft journal.
• ‒ Slide dry seal over guide sleeve.
• ‒ → Press oil seal in flush with fitting sleeve 3265.

Then proceed as for removing, performing steps in reverse order.