audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking chain tensioner - "engine generation III” > < Removing and installing oil pump - "engine generation II”

A4 Mk1

Removing and installing oil pump - “engine generation III”
Removing and installing oil pump - “engine generation III”
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
t  TORX wrench T45
  W00-10211
Removing
–  Remove sump (bottom section) → Chapter.
–  Place used oil collection and extraction unit -V.A.G 1782- under engine.
–  Unbolt brackets -arrows- and pull off long oil supply pipe from below.
  A17-0071
–  Unscrew chain sprocket using TORX wrench T45 -arrow- and pull it off oil pump.
  A17-0072
–  Remove oil pump together with short oil supply pipe -arrows-.
Installing
Installation is carried out in the reverse order; note the following:
l  Chain sprocket can only be fitted in one position on oil pump shaft.
–  Install sump (bottom section) → Chapter „Installing sump (bottom section) - engines with moulded gasket“ or → Chapter „Installing sump (bottom section) - engines with liquid gasket“.
Tightening torques
  A17-0075
ComponentNm
Oil pump to cylinder block22
Chain sprocket to oil pump shaft25
Bracket to sump (top section)10

   

Checking chain tensioner - "engine generation III” > < Removing and installing oil pump - "engine generation II”