A4 Mk1
Coolant pipes - exploded view of components |
1 - | To coolant hose (front) |
2 - | Coolant pipe (front) |
q | Removing and installing → Chapter |
3 - | Bleeder screw, 15 Nm |
4 - | Coolant hose |
q | From continued circulation coolant pump to front coolant pipe |
5 - | Continued coolant circulation pump -V51- |
q | Removing and installing → Chapter |
6 - | Coolant hose |
q | From rear coolant pipe to continued circulation coolant pump |
7 - | Coolant pipe (right-side) |
q | From turbocharger to rear coolant pipe |
8 - | Banjo bolt, 35 Nm |
9 - | Coolant temperature display sender -G2-/coolant temperature sender -G62- |
10 - | Retaining clip |
q | Check for firm attachment |
11 - | To heat exchanger |
12 - | Coolant pipe (rear) |
q | Removing and installing → Chapter |
13 - | 10 Nm |
14 - | Coolant pipe (right-side) |
q | From cylinder block to turbocharger |
15 - | Banjo bolt, 35 Nm |
16 - | Banjo bolt, 35 Nm |
17 - | Coolant pipe (right-side) |
q | From cylinder block to turbocharger |
18 - | From heat exchanger |
19 - | To coolant hose (front) |
20 - | Coolant pipe (small) |
q | Removing and installing → Chapter |
21 - | Bleeder screw or connection |
q | Tighten bleeder screw to 15 Nm |
22 - | Banjo bolt, 35 Nm |
23 - | Coolant pipe (left-side) |
q | From turbocharger to rear coolant pipe |
24 - | Thermo-switch for continued coolant circulation -F95- |
25 - | To oil cooler |
26 - | Retaining clip |
q | Check for firm attachment |