A4 Mk1
| Sealing flanges and dual-mass flywheel - exploded view of components |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | M6: 10 Nm; M8: 30 Nm |
| q | Apply locking fluid to M8 bolt; locking fluid → Parts catalogue. |
| 2 - | Crankshaft oil seal |
| q | Renewing → Chapter |
| 3 - | 40 Nm |
| 4 - | Stop for torque reaction support |
| 5 - | 28 Nm |
| 6 - | Torque reaction support |
| 7 - | Sump (top section) |
| q | Removing and installing → Chapter |
| 8 - | 45 Nm |
| 9 - | M7 = 16 Nm; M8 = 22 Nm |
| 10 - | O-ring |
| q | Renew |
| 11 - | Dual-mass flywheel |
| q | Removing and installing → Chapter |
| 12 - | 60 Nm + 180° (1/2 turn) further |
| q | Renew |
| 13 - | Needle bearing |
| q | Extracting and driving in → Chapter |
| 14 - | Sealing flange (rear) with oil seal |
| q | Lubricate sealing lip of oil seal lightly |
| q | To install, push guide sleeve from installation kit onto crankshaft. |
| 15 - | 10 Nm |
| 16 - | Gasket |
| q | Renew |
| 17 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 18 - | 20 Nm |
| 19 - | Guide tube for oil dipstick |
| 20 - | Gasket |
| q | Renew |
| 21 - | Sealing flange (front) |
| q | Removing and installing → Chapter |
