audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing bulb for turn signal > < Renewing bulb for main beam headlights

A4 Mk1

Renewing bulb for side lights
Renewing bulb for side lights
Removing
  WARNING
Always disconnect the battery earth strap before working on parts of the gas discharge headlights marked with yellow high-voltage warning symbols.
   
Removing
–  With ignition switched off, disconnect earth cable at battery → Chapter.
Headlight (left-side):
–  Remove cover -arrow- from power steering reservoir.
  A10-1160
Headlight (right-side):
–  Detach cover (right-side) -arrow- in engine compartment.
  A13-0368
–  Unscrew bolts -arrows-.
–  Remove air ducts -1- and -2-.
  A10-0746
Both sides (continued):
–  Unplug electrical connector on housing cover.
–  Release retaining clip -2- and detach housing cover -1- from headlight housing.
  A94-10363
–  Release the two retainer tabs and pull bulb holder -1- out of headlight housing -arrow-.
–  Pull bulb for side lights out of bulb holder.
Installing
Installation is carried out in the reverse order; note the following:
–  Insert new bulb in bulb holder, taking care not to touch glass bulb with bare hands.
–  Press bulb holder into headlight housing until you feel it engage.
–  Close housing cover and secure with retaining clip.
–  Connect battery. Additional steps required → Anchor.
  A94-10365

Renewing bulb for turn signal > < Renewing bulb for main beam headlights