–
| Release headlight range control motor -2-: at right-side headlight by turning anti-clockwise; at left-side headlight by turning clockwise -arrow-. |
–
| Press ball head of actuator shaft downwards out of its mounting by tilting control motor. |
–
| Unplug electrical connector -1-. |
Installation is carried out in the reverse order; note the following: |
–
| Start by inserting ball head of actuator shaft in mounting on reflector from below; to do so, pull reflector to rear. |
–
| Close housing cover and secure with retaining clip. |
Note The headlights must always be re-adjusted if the control motors are removed and installed or renewed → Booklet802. |
|
|
|