audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing hazard warning light relay J2 - vehicles up to 01.1999 > < Removing and installing 8-position relay carrier

A4 Mk1

Removing and installing A-pillar connector point (left-side)
Removing and installing A-pillar connector point (left-side)
   
Removing
–  With ignition switched off, disconnect earth cable at battery → Chapter.
–  Remove lower A-pillar trim → Rep. Gr.70.
–  Press retaining clip in direction of -arrow- and detach connector point -1- from A-pillar.
–  Unclip fuse holder from connector point.
–  Pull out relays or control units and then unclip corresponding relay carrier.
  Note
Exact assignment of connector point can be found in appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
–  Install lower A-pillar trim → Rep. Gr.70.
–  Connect battery. Additional steps required → Anchor.
  A97-10192

Removing and installing hazard warning light relay J2 - vehicles up to 01.1999 > < Removing and installing 8-position relay carrier