audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Adaption > < Encoding control unit

A4 Mk1

Reading measured value block
Reading measured value block
   
Sequence of operations
–  Start dash panel insert self-diagnosis → Chapter.
Display on -VAS 5051B-:
–  From list -1-, select function “08 - Reading measured value block”.
  A01-0122
Display on -VAS 5051B-:
1 - Enter display group
–  Use keypad -2- to enter the desired “display group number” → Anchor and confirm the entry by touching the Q key.
  A01-0130
Display on -VAS 5051B-:
1 - Display zones 1 ... 4. If a display zone is not assigned, there is no display on this line.
2 - The display group selected is shown here
3 - Touching these keys permits switching to a different display group.
4 - Touching these keys permits switching to a different function (e.g. from “Reading measured value block” to “Basic setting” and vice versa).
  Note
t  The display always shows the actual sender and sensor values. The values displayed on the dash panel insert may differ due to filtering.
t  If the actual coolant temperature is between 80 and 100 °C, the display on the dash panel insert is always 90 °C.
–  Terminate function “08 - Reading measured value block” by touching ← key.
  A01-0176
List of display groups
Display group 001
Display zonesExplanatory notes
1… km/hVehicle speed
2… rpmEngine speed
3 Oil pressure switch 2
Oil p.2…
l  Oil p.2 < min
l  Oil p.2 OK
4 Not used

   
Display group 002
Display zonesExplanatory notes
1… kmMileage counter
2… lFuel gauge
3 Not used
4 Ambient temperature (Highline dash panel insert only)
… °C
l  –40 … +70 °C

   
Display group 003
Display zonesExplanatory notes
1 Coolant temperature
… °C
l  50 … 130 °C
2 Not used
3 Not used
4 Not used

   

Adaption > < Encoding control unit