| Service interval display reset on completion of service without -VAS 5051B- |
| t
| The service prompt must be reset on completion of service. |
| t
| The service interval display should only be reset with the vehicle diagnostic, testing and information system -VAS 5051B- using the “Adaption” function → Anchor. |
Caution | If resetting is performed without -VAS 5051B-, service is automatically set to a fixed interval value. |
|
| If use is not made of -VAS 5051B-, the service interval display can be reset by implementing the following procedure: |
| –
| Press and hold the trip recorder reset button in the dash panel insert. |
| –
| Switch on the ignition whilst pressing the button. |
| “SERVICE!” appears on the display after releasing the trip recorder button. |
| –
| Press the time setting knob in the dash panel insert within 5 seconds until the message is reset to “SERVICE IN 15000 KM”. |
Note | The “adaption channels 40, 41, 46, 47, 48” used to display the dynamic service values are automatically set to “0”. |
| If resetting is performed without -VAS 5051B-, service is automatically set to a fixed interval: |
|
|
|
