A4 Mk2
| Removing and installing rear lid lock and handle mechanism |
| 1 - | Rear lid lock |
| q | To remove, unclip operating rod from joint bush and disengage. |
| q | Unscrew hexagon nuts -3- and remove rear lid lock. |
| 2 - | Joint bush |
| q | After installing rear lid lock, engage and secure operating rod. |
| 3 - | Nut |
| q | 8 Nm |
| 4 - | Operating rod |
| 5 - | Bowden cable |
| 6 - | Lock cylinder |
| q | Removing: |
| q | Unplug electrical connectors. |
| q | Disengage Bowden cable -6- from lock cylinder. |
| q | Unscrew bolt with washer -7-. |
| q | Turn lock cylinder through 90°. |
| q | Take lock cylinder out of handle mechanism. |
| 7 - | Bolt with washer |
| q | 8 Nm |
| 8 - | Motor |
| q | Removing and installing → Chapter |
| 9 - | Handle trim |
| q | Removing: |
| q | Rear lid trim removed |
| q | Lock cylinder removed |
| q | Unscrew hexagon flange nuts -10-. |
| q | Press in retaining hooks -arrows-. |
| q | Remove handle trim. |
| 10 - | Hexagon flange nut |
| q | 8 Nm |
