audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Emblems on rear lid - Avant > < Brand emblems and model badges from VIN 400 001 onwards

A4 Mk2

Emblems on rear lid - saloon
Emblems on rear lid - saloon
  Note
As reference edges for measurement use the bottom edge of the rear lid and the outside edge of the rear lid (at the point indicated by the height dimension).
Installing:
–  Allow vehicle and brand emblem to adjust to room temperature.
–  Bonding surfaces must be dry and free from dust and grease.
–  Clean outer panel with petrol, treat with silicone remover and rub dry.
–  Remove protective paper and press on parts of emblem -1- for approx. 3 seconds.
   
Dimensions for vehicles with front-wheel drive
t  a = 25 mm
t  b = 30 mm
t  c = 63 mm
t  d = 25 mm

   
Dimensions for vehicles with four-wheel drive

t  a = 25 mm
t  b = 30 mm
t  c = 63 mm
t  d = 25 mm
t  e = 4 mm
   

Emblems on rear lid - Avant > < Brand emblems and model badges from VIN 400 001 onwards