A4 Mk2
| Exploded view - window frame and window regulator |
| 1 - | Window frame |
| q | Removing: |
| q | Remove door trim → Trim, insulation; Rep. gr.70. |
| q | Pull door seal out of window frame. |
| q | Remove window regulator motor → Chapter / manual window regulator → Fig.. |
| q | Unplug electrical connectors. |
| q | Unscrew bolts -7- and -8-. |
| q | Unscrew bolts -3-, -4-, -6- and -10- and lift window frame with window regulator out of door. |
| q | Installing: |
| q | Insert window frame and window regulator into door from above. |
| q | Attach upper half of seal (on door side) into window frame (top). |
| q | Loosely screw in securing bolts -4- at front and rear. |
| q | Then loosely screw in bolts in the following sequence: -3-, -10- and -8-. |
| q | Hand-tighten fitted bolts -4-. |
| q | Press top of window frame -1- slightly inwards. |
| q | Tighten bolts -3- and -10- to 32 Nm. |
| q | Tighten fitted bolts -4- to 32 Nm. |
| q | Tighten bolt -8- to 10 Nm. |
| q | Tighten locking bolt -arrow- in window frame to 32 Nm. |
| q | Attach lower half of door seal to inner door panel. |
| q | Attach window regulator rail to inner door panel with bolt -7-. |
| q | Press threaded pins of window regulator drum through inner door panel until they engage → Anchor. |
|
|
|
|
|
|
