A4 Mk2
| Removing and installing backrest cover panel |
Note| t | The illustration shows the removal and installation of the backrest cover panel on a front seat with active head restraint system. |
| t | The removal and installation procedures for the backrest cover panel on a front seat without active head restraint system are similar to those for a front seat with active head restraint system. |
| 1 - | Front seat |
| 2 - | Fastening strip |
| q | Always on tunnel side |
| 3 - | Clip |
| q | 3x |
| q | Renew |
| 4 - | Backrest cover panel |
| t | Removing |
| – | Disengage footwell trim -8- from spring mat at tabs -7- (4x) on underside of seat. |
| – | Disengage fastening strip -2-. |
| – | Detach fastening strips -6- (2x) from side trim panels → Fig.. |
| – | At position marked with -arrow-, press against backrest cover panel -4- to prise out clips -3- (3x). |
| – | Disengage backrest cover panel -4- upwards from retainers -5- (2x). |
| t | Installing |
| Install in reverse order of removal. Note the following: |
| – | Renew clips -3- (3x). |
| – | Insert fastening strip of footwell trim in retainers on side trim → Fig.. |
| 5 - | Retainer |
| q | 2x |
| 6 - | Fastening strip |
| q | 2x |
| 7 - | Tab |
| q | 4x |
| 8 - | Footwell trim |
|
|
