A4 Mk2
|
|
|
|
|
|
|
WARNING
| 1 - | Backrest |
| t | Removing: |
| – | Remove seat → Chapter. |
| – | Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
| – | Attach front seat to seat repair stand -VAS 6136-. |
| – | Remove side trim (sill side) → Chapter. |
| – | Remove side trim (tunnel side) → Chapter. |
| – | Unscrew bolt -5-. |
| – | Swivel bracket -6- upwards. |
| – | Remove bolts -4- (4x). |
| – | Disengage fastening strip -9- from seat pan -7-. |
| – | Prise out backrest fittings -2- (2x) at guides in seat pan -7-. |
| – | Tilt backrest -1- forwards onto seat. |
| – | Press padding to side and carefully pull wiring harness -3- out of seat pan -7-. |
| – | Detach backrest -1-. |
| t | Installing: |
| Install in reverse order of removal. Observe the following: |
| – | On tunnel end, position spacer -8- on lower guide in seat pan so that spacer is flush with guide. |
| – | Always renew bolts -4- (4x). |
| – | Re-cut threads in backrest frame before inserting bolts -4- (4x). |
| Seat with seat memory: |
| – | After installing seat in vehicle, perform basic setting of backrest/seat. |
| 2 - | Backrest fitting |
| q | 2x |
| 3 - | Wiring harness |
| 4 - | Bolt, self-locking |
| q | 20 Nm |
| q | Renew |
| q | 4x |
| q | Always clean threaded holes (using e.g. a tap) |
| 5 - | Bolt |
| 6 - | Bracket |
| 7 - | Seat pan |
| 8 - | Spacer (tunnel end only) |
| 9 - | Fastening strip |
| 1 - | Cable tie |
| – | Cut through cable tie -1-. |
| – | Pull out rubber strap -2-. |
| – | Unplug connectors -4- (4x). |
| – | Unfasten adhesive strips at mounting rails -3- (5x). |
| 2 - | Rubber strap |
| 3 - | Mounting rail |
| q | 5x |
| 4 - | Connector |
| q | 4x |
