A4 Mk2
Removing and installing parts of ABS system on front axle |
1 - | Hexagon socket head bolt |
q | Tightening torques: 10 Nm |
2 - | Speed sensor |
q | Left and right identical |
q | Removing and installing → Chapter |
q | Connector for speed sensor → Chapter |
q | Grease all round with lubricating paste -G 000 650- before fitting in wheel bearing housing |
q | Push into wheel bearing housing as far as it will go. |
3 - | Drive shaft with rotor |
q | Checking rotor for dirt and damage → Anchor |
q | If rotor is damaged, outer C.V. joint must be renewed together with rotor → Rep. Gr.40 |
q | As replacement part, outer C.V. joint is supplied together with rotor. |
4 - | Speed sensor wire |
q | Fit into retainers provided |
5 - | Hexagon socket head bolt |
q | Always renew |
q | Different versions available → ETKA |
Vehicle must be standing on the ground when tightening |
Tightening torques → Rep. Gr.42 |