A4 Mk2
Note
|
1 - | Self-locking bolt, 35 Nm |
q | Always renew |
q | When loosening and tightening, counter-hold on guide pin |
2 - | Brake caliper housing with lever for handbrake cable |
q | Renew the brake caliper housing if there is a leak at the lever for handbrake cable |
q | After repairing, pre-bleed brake caliper housing → Chapter |
3 - | Bleeder valve |
4 - | Dust cap |
q | Fit onto bleeder valve |
5 - | Seal |
q | Removing and installing → Chapter |
6 - | Piston with automatic adjustment |
q | Removing and installing → Chapter |
7 - | Guide pin |
q | Lubricate before installing protective cap |
8 - | Protective cap |
q | Removing and installing → Anchor |
q | Push outer sealing lip onto piston |
9 - | Protective cap |
q | Insert onto brake carrier and guide pin |
10 - | Brake carrier with guide pins and protective caps |
q | Replacement carriers are supplied assembled and with sufficient grease on guide pins |
q | If protective caps or guide pins are damaged, renew using repair kit. Use grease sachet supplied to lubricate the guide pins. |