A4 Mk2
Removing and installing input shaft, pinion shaft, hollow shaft, selector rods, gearbox cover and cover with centre differential |
1 - | Gearbox housing |
2 - | Input shaft |
q | Dismantling and assembling → Chapter |
q | Adjusting → Chapter |
q | Servicing bearings for input shaft → Chapter |
3 - | Selector rod with selector fork for 3rd and 4th gear |
q | Dismantling and assembling → Chapter |
q | Renewing bearing bushes → Chapter |
4 - | Stop bolt (left-side) |
q | 40 Nm |
5 - | Washer |
6 - | Relay shaft |
q | Installation position → Item |
7 - | Washer |
8 - | Stop bolt (right-side) |
q | 40 Nm |
9 - | Selector shaft |
q | Installation position → Item |
q | Renewing selector shaft oil seal → Item |
10 - | Detent segment |
q | Installation position |
11 - | TORX bolt |
q | 25 Nm |
q | With collar to secure detent segment spring |
12 - | Selector rod with 1st/2nd/5th and reverse gear selector forks |
q | Dismantling and assembling → Chapter |
q | Removing and installing ball sleeves → Fig. |
13 - | pinion shaft with hollow shaft |
q | Dismantling and assembling → Chapter |
q | Adjusting → Chapter |
q | Servicing bearings for pinion shaft and hollow shaft → Chapter |
14 - | Gearbox cover |
q | Removing and installing oil collector → Fig. |
15 - | TORX bolt |
q | 22 Nm |
16 - | Spring |
17 - | Cover with centre differential |
q | Removing and installing with gearbox installed → Chapter |
q | Removing and installing centre differential in cover → Chapter |
q | Servicing cover → Chapter |
18 - | TORX bolt |
q | 22 Nm |