audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Engine oil > < Removing and installing oil filter bracket with engine oil cooler

A4 Mk2

Checking oil pressure and oil pressure switch
   
Checking oil pressure and oil pressure switch
Special tools and workshop equipment required
t  Oil pressure tester -V.A.G 1342-
t  Voltage tester -V.A.G 1527B-
t  Auxiliary measuring set -V.A.G 1594C-

Test conditions
l  Oil level OK
l  Engine oil temperature approx. 80 °C
   
Preparation for test
–  Unclip cover caps.
–  Unscrew nuts -arrows- and detach engine cover panel. Also pull out dipstick if necessary.
–  Remove insulation beneath cover panel (if fitted).
  A10-10348
–  Unplug electrical connector at oil pressure switch -F1-.
–  Unscrew oil pressure switch.
–  Connect oil pressure tester -V.A.G 1342- to threaded hole for oil pressure switch.
–  Screw oil pressure switch -F1--Item 2- into oil pressure tester -V.A.G 1342-.
Checking oil pressure switch
–  Connect brown wire -1- of oil pressure tester to earth (–).
–  Connect voltage tester -V.A.G 1527B- with test leads from auxiliary measuring set -V.A.G 1594C- to oil pressure switch and battery positive (+).
l  LED should not light up.
If LED lights up now:
–  Renew oil pressure switch.
–  Start engine.
  Note
Observe tester and LED while starting, as switching point of oil pressure switch may already be exceeded when starting.
l  LED should light up at 0.55 ... 0.85 bar.
If LED does not light up:
–  Renew oil pressure switch.
Checking oil pressure
–  Start engine.
l  Minimum oil pressure at idling speed: 0.8 bar.
l  Minimum oil pressure at 2000 rpm: 2.0 bar.
Assembling
Assemble in reverse order.
  A17-0025

Engine oil > < Removing and installing oil filter bracket with engine oil cooler