–
| Tighten securing bolts for camshaft sprocket -arrows- to 25 Nm. |
–
| Remove locking pin -3359- and crankshaft stop -T10050-. |
Caution The engine must only be turned at the crankshaft, in the direction of normal engine rotation (clockwise). |
|
–
| Turn crankshaft two rotations in normal direction of rotation until crankshaft is at TDC again. |
–
| Check valve timing once again → Anchor. |
Installation is carried out in the reverse order; note the following: |
Note t
| Renew seals and gaskets. |
t
| To ensure that the charge air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing. |
–
| Install toothed belt cover (bottom and centre). |
–
| Fit toothed belt cover (top section). |
–
| Install vibration damper: vehicles up to 05.2003 → Anchor, vehicles from 06.2003 onwards → Anchor. |
–
| Install poly V-belt: vehicles up to 05.2003 → Anchor, vehicles from 06.2003 onwards → Anchor. |
|
|
|