–
| Unscrew inner section of oil seal extractor -3203- 6 turns out of outer section and lock with knurled screw. |
–
| Lubricate threaded head of oil seal extractor, place it in position and screw it into oil seal as far as possible (applying firm pressure). |
–
| Loosen knurled screw and turn inner part against crankshaft until oil seal is pulled out. |
–
| Clamp flats of oil seal extractor in vice. |
–
| Remove oil seal with pliers. |
–
| Clean running surface and sealing surface. |
Note Do not lubricate sealing lip and outer rim of oil seal before pressing in. |
–
| Remove oil residue from crankshaft journal with a clean cloth. |
–
| Push on oil seal using fitting sleeve -3202/1-. |
|
|
|