audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling pistons and conrods > < Measuring radial clearance of crankshaft

A4 Mk2

Removing and installing chain sprocket
Removing and installing chain sprocket
Special tools and workshop equipment required
   
t  Drift sleeve -30-100-
  W00-0359
Removing
–  Remove chain for oil pump → Chapter
–  Pull chain sprocket off crankshaft with a puller -2- (normal commercial type); use a suitable washer -1- to protect end of crankshaft.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Installation position: lettering on chain sprocket must be visible.
–  Heat chain sprocket in oven for approx. 15 minutes to 220°C.
  WARNING
Wear protective gloves.
  A13-0058
–  Fit chain sprocket on end of crankshaft using pliers, and press onto crankshaft as far as the stop using drift sleeve -30-100-.
  A13-0059

Dismantling and assembling pistons and conrods > < Measuring radial clearance of crankshaft