audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing vibration damper > < Removing and installing tensioner for poly V-belt

A4 Mk2

Removing and installing idler roller for poly V-belt
Removing and installing idler roller for poly V-belt
Special tools and workshop equipment required
   
t  Socket Torx T 60 -T40087-
  W00-10244
Removing
–  Remove intake manifold (top section) → Rep. gr.23.
–  Loosen clamps -arrows-.
–  Pivot toothed belt cover forward and disengage retaining pegs on bottom side of toothed belt cover.
  A13-10033
–  Slacken poly V-belt by swivelling tensioner in direction of -arrow-, using socket Torx T 60 -T40087- and a long, straight-handled ring spanner or open-end spanner.
–  Remove poly V-belt from tensioning roller.
  A13-10174
–  Unscrew bolts -arrows- and detach idler roller from front sealing flange.
Installing
Installation is carried out in the reverse order; note the following:
–  Install poly V-belt → Chapter.
–  Install intake manifold (top section) → Rep. gr.23.
t  Tightening torque → Chapter
  A13-10328

Removing and installing vibration damper > < Removing and installing tensioner for poly V-belt