–
| Position the fuel tank with securing straps on underbody, using the engine and gearbox jack -V.A.G 1383 A-. |
–
| When installing fuel tank, make sure that the fuel filler neck is correctly inserted into the opening on the body. |
–
| Secure fuel tank by first tightening bolts at points -2, 5, 3, 4-, then at points -1, 6, 7-. |
–
| Secure fuel filler neck. |
Caution After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body: |
Specification: approx. 0 Ω. |
|
–
| Install rear right wheel housing liner and tighten securing bolt for fuel filler neck → Rep. Gr.66. |
Vehicles with auxiliary heater: |
–
| Let auxiliary heater run with full load for 10 minutes to bleed fuel supply pipe going to metering pump. |
|
|
|