audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Fuel supply system, petrol engines > < Removing and installing accelerator pedal module with accelerator position sender
Adapting kick-down function - vehicles with automatic gearbox
Adapting kick-down function - vehicles with automatic gearbox
  Note
If accelerator position sender or engine control unit is replaced, kick down function must be adapted on vehicles with automatic gearbox.
Special tools and workshop equipment required
   
t  Vehicle diagnostic, testing and information system -VAS 5051B- with diagnosis lead -VAS 5051/5A-
  W00-10343
Procedure
l  Vehicle diagnostic, testing and information system -VAS 5051B- connected with diagnosis lead -VAS 5051/5A-.
l  No faults stored in fault memory.
l  Engine stopped, ignition switched on
  A01-0201
Display on -VAS 5051B-:
–  From menu -1-, select “Self diagnosis” system and press key to activate function.
  A01-10007
Display on -VAS 5051B-:
–  From menu -1-, select vehicle system “01 - Engine electronics” and press key to activate function.
  A01-10008
Display on -VAS 5051B-:
–  From menu -1-, select function “006 - Basic setting” and press key to activate function.
  A01-10024
Display on -VAS 5051B-:
–  Press keys 63 on keypad -1- to select “Display group 063” and confirm entry by pressing key Q.
  A01-10026
–  Activate basic setting by touching Activate key -A-.
Display on -VAS 5051B-:
–  Check display in zones -3- and -4-.
Display shows: “Operate kickdown”
–  Fully depress accelerator pedal beyond kickdown point and keep it pressed.
Display shows: “Kickdown ADP runs”
–  Check the readout in display zones -3- and -4-.
Display shows: “Kickdown ADP O.K.”
  Note
t  If the display shows “Kickdown ERROR”: interrogate fault memory.
t  “ERROR” is indicated, for example, if the accelerator pedal is not pressed immediately after requested by the tester or if the accelerator pedal is released before the adaption process is finished. Exit function “006 - Basic setting” by pressing key and restart adaption.
–  End function “006 - Basic setting” by pressing key.
–  Select function “022 - End output”.
–  Switch off ignition and detach diagnostic connector.
  A01-10028

Fuel supply system, petrol engines > < Removing and installing accelerator pedal module with accelerator position sender