audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Navigation system RNS-E USA > < Overview of fitting locations (Avant)

A4 Mk2

Removing and installing navigation system with CD drive control unitJ401
Removing and installing navigation system with CD drive control unit -J401-
Special tools and workshop equipment required
   
t  Radio release tool -T10057-
–  When renewing control unit, select “Replacement” function for appropriate control unit in “Guided Fault Finding”.
To do so, use the vehicle diagnostic, testing and information system -VAS 5051-.
–  Switch off all electrical equipment.
–  Remove ignition key.
Removing
  W00-1042
–  Insert radio release tools -T10057--arrows- into slots on operating electronics control unit for navigation -J402- until they engage. Pointed ends of grips must face outwards.
–  Pull operating electronics control unit for navigation -J402- out of dash panel.
–  Release and unplug electrical connectors at operating electronics control unit for navigation -J402-.
–  Press release tabs on operating electronics control unit for navigation -J402- and remove radio release tool -T10057-.
Installing
–  Plug in all connectors.
–  Slide operating electronics control unit for navigation -J402- carefully into dash panel and engage it in mounting frame.
  A91-10734

Navigation system RNS-E USA > < Overview of fitting locations (Avant)