Audi Workshop Service and Repair Manuals > A4 Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Rear lights - vehicles from 11.2004 | Removing and installing inner rear light (Avant)

Removing and installing inner rear light (Avant)

Removing

–	Switch off ignition and take out ignition key.

–	Turn light switch to position “0”.

–	Unclip plug -1- from luggage compartment trim -arrow- using a small screwdriver.

–	Unscrew nut -2- and remove retainer bracket and bulb holder -3-.

–	Remove nut -4- and remove inner rear light -1- from outside in direction of -arrow-.

–	Pull the retainer -5- out of body opening.

Installing

Installation is carried out in the reverse order; note the following:

Note

Ensure that seal between body and rear light housing seals completely.

–	Position inner rear light at outer edge of rear lid.

–	Push retainer onto stud for inner rear light, fit bulb holder and tighten nut.

Note

As the nut is tightened the retainer becomes wedged at the inner rear light and the rear lid.

–	Clip plug into luggage compartment lining.

Tightening torques

Audi Workshop Service and Repair Manuals