Audi Workshop Service and Repair Manuals > A4 Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Rear lights - vehicles up to 10.2004 | Removing and installing rear light and bulb carrier (Avant)

Removing and installing rear light and bulb carrier (Avant)

Removing

–	Switch off ignition and take out ignition key.

–	Turn light switch to position “0”.

–	Remove plug -arrow- from luggage compartment lining.

–	Remove bolt -1-.

–	Swivel rear light outwards, and at the same time disengage retaining pins from body.

–	Unplug electrical connector at bulb carrier.

–	Press apart retaining clips -arrows- and take bulb carrier out of rear light.

–	Turn bulbs to remove them from their holders.

Installing

Installation is carried out in the reverse order; note the following:

Note

Ensure that seal between body and rear light housing seals completely.

–	Fit rear light in position on body and press retaining pins into holes.

–	Tighten bolt -1-.

Note

After unfastening nut -2-, rear light can be aligned with body contours (uniform gap widths).

Tightening torques

Audi Workshop Service and Repair Manuals