audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view of storage compartment > < Removing and installing seat depth adjuster

A4 Mk3

Removing and installing trim for seat depth adjuster
Removing and installing trim for seat depth adjuster
Special tools and workshop equipment required
   
t  Removal wedge -3409-
Removing
  WARNING
t  Observe safety regulations for pyrotechnic components → Chapter.
t  Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar.
–  Remove front seat:
t  Sports seat (with manual adjustment) → Chapter „Removing and installing front standard seat (with manual adjustment)“.
t  Sports seat (with electric adjustment) and super sports seat → Chapter „Removing and installing front standard seat (with electric adjustment)“.
–  Attach front seat to seat repair stand -VAS 6136- → Chapter.
–  Equipment version with storage compartment: Remove storage compartment → Chapter.
  W00-0016
–  Set seat depth adjuster as far forwards as it will go.
–  Unclip retaining tabs -arrows- at trim -1- using removal wedge -3409-.
–  Detach trim from seat depth adjuster.
Installing
  WARNING
t  Observe safety regulations for pyrotechnic components → Chapter.
t  Before handling pyrotechnic components (e.g. plugging in the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar.
Installation is carried out in the reverse order; note the following:
  Note
Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.
  WARNING
The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery.
–  With ignition switched on, connect battery earth wire → Electrical system; Rep. gr.27.
  Note
If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester.
  A72-11562

Exploded view of storage compartment > < Removing and installing seat depth adjuster