A4 Mk3
| Exploded view of front standard seat (with manual adjustment) |
Note| t | The exploded view relates to the driver's seat. The front passenger's seat is similar; the attachments are fitted on the opposite sides. |
| t | For greater clarity, the floor covering is not shown in the illustration. |
| 1 - | Storage compartment |
| q | Depending on equipment version |
| q | Exploded view → Chapter |
| q | Removing and installing → Chapter |
| 2 - | Seat longitudinal adjuster |
| q | Exploded view → Chapter |
| q | Removing and installing → Chapter |
| 3 - | Cover |
| q | For seat rail (front right) |
| q | Removing and installing → Chapter |
| 4 - | Bolt |
| q | 50 Nm |
| 5 - | ISOFIX child seat anchor |
| q | Depending on equipment version |
| q | For front passenger's seat only |
| q | Exploded view → Chapter |
| q | Removing and installing → Chapter |
| q | Checks to be performed following an accident → Chapter |
| 6 - | Trim (tunnel side) |
| q | Removing and installing → Chapter |
| 7 - | Bolt |
| q | 50 Nm |
| 8 - | Front standard seat (with manual adjustment) |
| q | Removing and installing → Chapter |
| 9 - | Head restraint |
| q | With manual adjustment |
| q | Exploded view → Chapter |
| q | Removing and installing → Chapter |
| 10 - | Cover |
| q | For seat rail (rear right) |
| q | Removing and installing → Chapter |
| 11 - | Backrest adjuster |
| q | Removing and installing → Chapter |
| 12 - | Bolt |
| q | 50 Nm |
| 13 - | Cover |
| q | For seat rail (rear left) |
| q | Removing and installing → Chapter |
| 14 - | Lower seat pan frame |
| q | On a standard seat (front, with manual adjustment), the lower seat pan frame (with seat longitudinal adjustment) should not be separated from the upper seat pan frame |
| 15 - | Seat height adjustment unit |
| q | Exploded view → Chapter |
| q | Removing and installing → Chapter |
| 16 - | Trim (sill side) |
| q | Removing and installing → Chapter |
| 17 - | Driver seat lumbar support adjustment switch -E176- |
| q | Passenger side: front passenger seat lumbar support adjustment switch -E177- |
| q | Depending on equipment version |
| q | Exploded view → Chapter |
| q | Removing and installing lumbar support adjustment switch → Chapter |
| q | Removing and installing four-way lumbar support → Chapter |
| 18 - | Cap |
| q | For connector point |
| q | Removing and installing → Chapter |
| 19 - | Connector point |
| q | Connector assignment → Chapter |
| 20 - | Cover |
| q | For seat rail (front left) |
| q | Removing and installing → Chapter |
| 21 - | Bolt |
| q | 50 Nm |
| 22 - | Corrugated tube |
| q | For modular wire routing |
| q | Exploded view → Chapter |
| q | Modular wire routing with corrugated tube at front seat → Chapter |
