Audi Workshop Service and Repair Manuals

Removing and installing oil seal for selector shaft with gearbox installed Special tools and workshop equipment required

t  Extractor tool -T20143/1-

t  Shock absorber set -T10001/1-

t  Puller -T40160- t  Sealing grease -G 052 128 A1-

Removing –  Engage 1st gear. –  Remove rear noise insulation (loosen fasteners -2- and -3-).

–  Remove nut -1-.   Note -Item 2- can be disregarded.

Caution Risk of damage to selector shaft in gearbox. Do not prise off or knock off the gearbox selector lever -1- with a lever or hammer. –  Apply puller -T40160- and pull off gearbox selector lever -1-.

–  Prise out oil seal with extractor hook -T20143/1-. l  Check selector shaft for damage.

Installing –  Lightly oil outer circumference of oil seal. –  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. –  Drive in oil seal with -T10001/1-. l  Installation depth: 2 mm below outer edge of housing

–  Install gearbox selector lever as follows: l  Gearbox selector lever -2- can only be fitted onto selector shaft -1- in one position (gap in splines -arrow-). –  Secure gearbox selector lever; tightening torque → Item. –  Install rear noise insulation → Rep. gr.66.