A4 Mk3
Exploded view - selector mechanism |
1 - | Circlip |
q | Take out before removing ball |
2 - | Spacer sleeve |
3 - | Spring |
4 - | Ball guide |
q | Do not grease |
5 - | Ball |
q | Do not grease |
6 - | Damper |
q | For gear lever bearing → Item |
q | Do not grease |
7 - | Bolt |
q | 23 Nm |
8 - | Clamping plate |
q | Do not grease |
9 - | Gear lever |
q | Bend points towards rear |
q | Grease gear lever stops and guide for reverse gear detent; for grease refer to → Electronic parts catalogue |
q | Grease contact surfaces for joint → Item; for grease refer to → Electronic parts catalogue |
10 - | Spacer tube |
q | Grease outside circumference; for grease refer to → Electronic parts catalogue |
11 - | Gear lever bearing |
q | Removing and installing → Chapter |
q | Do not grease |
12 - | Joint |
q | Between selector rod and gear lever |
q | Grease contact surfaces for gear lever; for grease refer to → Electronic parts catalogue |
13 - | Bolt |
q | For joint → Item |
14 - | Bolt |
q | 23 Nm |
15 - | Nut |
q | 10 Nm |
16 - | Selector rod |
17 - | Push rod |
q | With bolt and washer |
18 - | Nut |
q | 20 Nm |
q | Always renew |
19 - | Bolt |
q | 4 Nm |
20 - | Gearbox selector lever |
q | Install so that gap in splines aligns with selector shaft |
q | Apply grease if necessary; for grease refer to → Electronic parts catalogue |
21 - | Sealing collar |
22 - | Ball socket |
q | Apply grease; for grease refer to → Electronic parts catalogue |
23 - | Bearing bush |
q | To remove pull off retaining clip → Item. |
24 - | Connecting rod |
q | To remove pull off retaining clip → Item. |
25 - | Bolt |
q | 20 Nm |
26 - | Retaining clip |
27 - | Bolt |
q | 20 Nm |